Evolution v-tail

The preceding X-Tail version has fulfilled the goal for which it was designed. This is shown mainly by the victory of Andreas Böhlen in the Eurotour Contest in Salzburg and Hans Rossman at the Hohe Wand 2008 and many others placed in the contests. The standard version is made for the 2.4 GHz system...

Evolution

Evolution x-tail

The contest model Evolution is made for the F3B model category. The design by Günther AichHolzer follows the current trend in the development of models for this category. This means a small fuselage diameter, a thinner wing and smaller wing area in comparison to the model Eagle.

Evolution

Eagle v-tail

Model for use in F3B and F3F categories. It is produced in cooperation and under the design of the Austrian represent Guenter Aichholzer. It fulfills all the requests put on a F3B model. The tail has a v-conception. This construction makes it possible to lower the flying weight.

Eagle v-tail

Eagle x-tail

The contest model Evolution is made for the F3B model category. The design by Günther AichHolzer follows the current trend in the development of models for this category. This means a small fuselage diameter, a thinner wing and smaller wing area in comparison to the model Eagle.

Eagle x-tail

X-21 v-tail

Model made for flying in the F3B, F3F and F3J categories. The model is made in fullcarbon version, which can withstand more stress. The F3J version of the model is lighter. The flying performance suits beginner F3x pilots also.

Eagle x-tail

Xantipa II

The design of the model results from long experience of the constructor in the F3J category and is optimized for top-performance contest flying. The construction allows extremely fast starts with maximum of height. The used airfoil gives the model a wide range of useable speeds

Xantipa II
Desing and Programing: Michal Michna - 2009
  • © Jiri Tuma - JiTom
  • www.jitom.com
  • 2006-2009